RESTRICTED USE ONLY
Selecting the Lamination Position
Step
Procedure
1
Use the Lamination Position control to adjust the horizontal position of
the PolyGuard Overlaminate. (Note: This control functions in the same
manner as the Image Position controls, except only the horizontal position
of the overlaminate requires adjustment.)
•
To adjust the Lamination position, click on the Horizontal adjustment
arrows.
•
To move the overlaminate more toward the card output side of the
Printer, enter a positive number.
•
To move the overlaminate more toward the card input side of the
Printer, enter a negative number. (Note: The adjustment arrows point
in the direction the patch will move on the card. The maximum value for
the Horizontal adjustment is ±100 Pixels (10 Pixels = about .03/.8mm)
The default is 0.)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Fargo Electronics, Inc.
8-83