FARGO electronics HDP5000 single-side User Manual page 91

RESTRICTED USE ONLY
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message
Cover is Open
(PC Error Message
No. 46)
E-Card Encoder
Startup Error
(PC Error Message
No. 141)
E-Card Startup Error
(PC Error Message
No. 141)
EEPROM Corrupt
(PC Error Message
Nos. 38, 39, 40, and
144)
Ejecting Card
(PC Error Message
No. 72)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Cause
The Cover was left open.
A problem was detected
during Printer start-up.
A problem was detected
during Printer start-up.
EEPROM restored with
factory default values.
The card has been ejected
already.
Fargo Electronics, Inc.
Solution
Ensure that the Cover is
properly closed.
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
If changes were made, then go
into the setting values and
reset these numbers.
Click OK to clear the
message. The User might
want to know that a card has
been sent to the reject bin, or
out of the printer, and is either
incomplete or posses a
security risk if not disposed of
properly.
5-7