RESTRICTED USE ONLY
Restoring the Factory Settings for Ethernet
There may be times when you are unable to use the current configuration of the Ethernet
interface. (Note: This could be because you have lost the password for your Printer or you
just cannot get it to work properly.)
Resetting the HDP5000 settings
The HDP5000 has a menu selection that allows the User names and passwords to revert to
default. To reset these settings, select:
Menu: Setup Printer: Network Settings: Reset Passwords.
Changing the HDP5000 LCD Network Settings
The HDP5000 Printer/Encoder will display new menu entries when (a) the Ethernet option is
installed and (b) the Printer has established communications to a host device.
• You can use these procedures to change network settings by using the new LCD menus.
Accessing the Network Setup Menu
Step
Procedure
1
Apply power to the Printer.
2
Ensure that the Printer is connected to your network.
3
Wait up to one (1) minute to allow the Printer to configure the IP address.
4
Select Options on the LCD.
5
Select Menu on the LCD.
6
Select the Next button on the LCD until the Network Settings menu entry
appears.
7
Press Select when Network Settings appears on the LCD.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Fargo Electronics, Inc.
6-50