Preparing To Set Up Business Continuity Manager - HP XP P9500 Software User's Manual

Figure 8 Serial Numbers on an XP24000/XP20000 or P9500 Disk Array
Each logical disk controller has a logical DKC number (0 or 1) assigned within the storage system.
A procedure for identifying storage systems and storage system serial numbers that are different
for each storage subsystem is required.
Table 6 (page 39)
storage system serial numbers on each storage system model.
Table 6 Business Continuity Manager Identification of Storage System Models and Serial Numbers
Storage system model
XP1024/XP128 or XP12000/XP10000
Disk Array
XP1024XP24000/XP20000 or P9500
Disk Array

Preparing to set up Business Continuity Manager

After Business Continuity Manager is installed and configured for each data center in the
configuration, you must perform some initial setup tasks. For more information about these tasks,
see "Preparing to use Business Continuity Manager" (page 99)
describes how Business Continuity Manager identifies storage systems and
What is considered
to be a storage
system
Storage system
Logical DKC
What is considered to be a storage system
serial number
Physical DKC serial number
Logical DKC serial number
Preparing to set up Business Continuity Manager 39