Definition Procedure (3Dc Cascade Configuration) - HP XP P9500 Software User's Manual

Table 36 How to Prepare the Configuration Files at each site (3DC Cascade Configuration) (continued)
File Type
Path set definition file
Route list definition
file/Command device
definition file
Copy group definition file
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.

Definition procedure (3DC Cascade configuration)

First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 34 (page
This section explains how to set up a 3DC Cascade configuration from the ISPF panel.
The following shows the legend for the figure in the operation procedure of this section:
Contents
An inter-control unit
logical path from the
primary site to the
intermediate site
An inter-disk controller
logical path from the
intermediate site to the
remote site
An inter-control unit
logical path from the
intermediate site to the
primary site
An inter-disk controller
logical path from the
remote site to the
intermediate site
A route/command device
from the primary site, to the
intermediate site, and then
the remote site
A route/command device
from the remote site, to the
intermediate site, and then
the primary site
A Cnt Ac-S Z copy group
A Cnt Ac-J Z copy group
137).
How to Prepare
On the Primary Site
Define a path set
Not required
Define a route list
Not required
Define a copy group
Define a copy group
Defining a 3DC Cascade configuration 139
On the Secondary Site
Not required
Define a path set
Not required
Define a route list
Transfer from the primary
site