Protocol Settings; Settings From The Control Panel - Canon MF7280 - ImageCLASS B/W Laser Network Manual

Protocol Settings

You can specify the protocol settings for the machine by using any of the following:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Device Installer (Canon utility)
• NetSpot Console (via a web browser) (Canon utility)
IMPORTANT
•
If you are configuring the TCP/IP settings for the first time, use the control panel of this
machine or NetSpot Device Installer. After configuring the settings, you can change the
content by using the Remote UI or NetSpot Console.
•
Some items cannot be set using NetSpot Device Installer. For details about items that
can be set with NetSpot Device Installer, see "Network Setting Items," on p. 7-2.
NOTE
•
For instructions on how to enter settings using the Remote UI, see Chapter 3,
"Customizing Settings," in the Remote UI Guide.
•
For more information on NetSpot Device Installer or NetSpot Console, see Chapter 5,
"Using Utilities to Make Network and Device Settings."
•
NetSpot Console can be downloaded from Canon's Web site
(http://www.usa.canon.com).

Settings from the Control Panel

The procedures for specifying the settings from the control panel are as follows.
IMPORTANT
Settings specified from the control panel become effective after the machine is restarted,
after the procedure.
NOTE
For instructions on how to enter characters using the touch panel display, see Chapter 2,
"Basic Operations," in the Reference Guide.
4-3

Protocol Settings

4