Canon MF7280 - ImageCLASS B/W Laser Network Manual page 40

NOTE
•
Only one of the DHCP, BOOTP, or RARP settings can be selected at any one time.
•
Even if you press [DHCP], [BOOTP], or [RARP], you should enter an IP address,
subnet mask, and gateway address. If this information cannot be obtained from the
DHCP, BOOTP, or RARP server, the settings entered in this step are used.
•
If the machine is restarted after DHCP, BOOTP, or RARP settings are complete, the
TCP/IP Settings screen displays the IP address setting values obtained from the
DHCP, BOOTP, or RARP server. (If the IP address, host name, and domain name
have been previously set, these will be overwritten by the setting values obtained
from DHCP, BOOTP, or RARP.)
•
It takes about two minutes to check whether the DHCP, BOOTP, or RARP settings
can be used. If you do not plan to use one of these settings, it is recommended that
you turn them off.
7
Confirm the settings you specified ➞ press [OK].
The display returns to the TCP/IP Settings screen.
8
If you use a DNS server, press [DNS Server].
Otherwise, skip to step 13.
3-7
Protocol Settings
3