NetBIOS Network Setup Procedures
To use a NetBIOS network, it is necessary to perform the following procedures.
1
4
2
3
IMPORTANT
•
It is recommended that steps 1 and 3 above be performed by the network manager.
•
The only base protocol supported by a NetBIOS network is TCP/IP. NetBEUI is not
supported with the machine.
•
Use the control panel or NetSpot Device Installer if you are configuring the TCP/IP
settings for the first time. After configuring the settings, you can change the content by
using the Remote UI or NetSpot Console.
NOTE
NetSpot Console can be downloaded from Canon's Web site
(http://www.usa.canon.com).
4-2
NetBIOS Network Setup Procedures
Protocol Settings (See "Protocol Settings," on p. 4-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Console (via a web browser) (Canon utility)
Computer Settings for Printing/Sending a Fax
(See "Setting Up a Computer for Printing/Sending a Fax," on p. 3-24.)
Specify the settings of each computer you use for printing or sending a fax.
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 4-9.)
Specify the settings of the computer receiving data sent from the machine.