Protocol Settings - Canon MF7280 - ImageCLASS B/W Laser Network Manual

Protocol Settings

You can specify the protocol settings for the machine by using any of the following:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Device Installer (Canon utility)
• NetSpot Console (Canon utility)
IMPORTANT
•
If you are configuring the protocol settings for the first time, use the control panel of this
machine or NetSpot Device Installer. After configuring the protocol settings, you can
change the content by using the Remote UI or NetSpot Console.
•
Some items cannot be set using NetSpot Device Installer. For details about items that
can be set with NetSpot Device Installer, see "Network Setting Items," on p. 7-2.
•
You can maintain security by setting the range of IP addresses of computers that can
obtain access to the machine.
- Once you set the range of IP addresses of computers on which items for the machine
can be set or browsed, it is not possible to use the Remote UI on computers whose IP
addresses are not allowed; a utility on the computers cannot be used to set or browse
detailed information concerning the machine.
- Once you set the range of IP addresses of computers from which data (print/fax/I-fax
job) can be sent to the machine, the machine rejects data sent from computers whose
IP addresses are not allowed. For instructions on how to specify the IP address range,
see step 19 in "TCP/IP Settings," on p. 3-4.
•
When using functions to access external servers on the internet, you may not be able to
access them due to the settings of firewalls, etc. In this case, consult your network
administrator.
NOTE
•
For instructions on how to enter settings using the Remote UI, see Chapter 3,
"Customizing Settings," in the Remote UI Guide.
•
For more information on NetSpot Device Installer or NetSpot Console, see Chapter 5,
"Using Utilities to Make Network and Device Settings."
•
NetSpot Console can be downloaded from Canon's Web site
(http://www.usa.canon.com).
3-3

Protocol Settings

3