Canon MF7280 - ImageCLASS B/W Laser Network Manual page 60

■ Changing the Port after Installing the Driver
1
Install Canon LPR2, and change the port settings.
If you do not want to use Canon LPR2, proceed to step 2.
For instructions on how to install Canon LPR2 and set ports, see Chapter 1,
"Using Canon LPR2," in the Canon LPR2 User's Guide (PDF manual) on the
UFR II Printer Kit/Super G3 FAX Board CD-ROM.
If you use Canon LPR2, the port changes are complete.
IMPORTANT
If you use LPD, enter one of the following in [LPR Queue Name] in the [Add Port]
dialog box of Canon LPR2:
- LP
The machine prints according to its spool settings. Normally enter <LP> as a print
queue.
- SPOOL
The machine prints only after spooling a print job on the hard disk, regardless of
its spool settings.
- DIRECT
The machine prints without spooling a print job on the hard disk, regardless of its
spool settings.
NOTE
If you are using Windows 2000/XP/Server 2003, you can set LPD or Raw by using
the standard feature of your OS, without installing Canon LPR2. If you do not want
to use Canon LPR2, see steps 2 to 11.
2
Open the printer properties dialog box.
❑
If you are using Windows 2000, on the [Start] menu, point to [Settings] ➞ click
[Printers].
❑
If you are using Windows XP Professional/Server 2003, on the [Start] menu,
click [Printers and Faxes].
❑
If you are using Windows XP Home Edition, on the [Start] menu, point to
[Control Panel] ➞ point to [Printers and Other Hardware] ➞ click [Printers and
Faxes].
3
Right-click the icon of the printer you installed ➞ click
[Properties].
Setting Up a Computer for Printing/Sending a Fax
3
3-27