TCP/IP Network Setup Procedures
To use a TCP/IP network, it is necessary to perform the following procedures.
1
3
2
3
IMPORTANT
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
Use the control panel of this machine or NetSpot Device Installer if you are configuring
the protocol settings for the first time. After configuring the protocol settings, you can
change the content by using the Remote UI or NetSpot Console.
NOTE
NetSpot Console can be downloaded from Canon's Web site
(http://www.usa.canon.com).
3-2
TCP/IP Network Setup Procedures
Protocol Settings (See "Protocol Settings," on p. 3-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Device Installer (Canon utility)
•
NetSpot Console (Canon utility)
Computer Settings for Printing/Sending a Fax
(See "Setting Up a Computer for Printing/Sending a Fax," on p. 3-24.)
Specify the settings for each computer you use for printing or sending a fax.
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 3-35.)
Specify the settings of the computer receiving data sent from the machine.