Canon MF7280 - ImageCLASS B/W Laser Network Manual page 121

Cause 3 The computer that is printing is not properly set up.
Remedy Check the following:
•
Confirm that the proper printer driver is installed. If you are printing from
Windows, each computer must have a printer driver installed. For instructions
on how to install printer drivers, see the Starter Guide.
•
Confirm that the correct printer is set as the output destination for the
computer that is printing. Check the output destination in [Printer] in [Control
Panel].
•
If you are using LPD with Windows 98/Me, follow the procedures below to
confirm the spool settings: On the [Start] menu, point to [Settings] ➞ click
[Printers]. Right-click the printer icon you are using ➞ on the pop-up menu,
click [Properties]. Click the [Details] tab to display the [Details] sheet. Click
[Spool Settings] to open the [Spool Settings] dialog box. Confirm that [Spool
print jobs so program finishes printing faster] is selected. If it is not selected,
select it ➞ click [OK].
Cause 4 The name of the file being printed is too long.
Remedy Normally LPR sends jobs either under the name of the application software
used for printing or under the file name. However, a job name longer than 255
characters cannot be sent to the printer. To correct this problem, rename the file
with a shorter name.
Cause 5 The IP address of the computer from which data (print/fax/I-fax job) is to be sent
to the machine is not permitted by the settings for [IP Address Range Settings].
Remedy Check the settings for [IP Address Range Settings]. (See step 19 in "TCP/IP
Settings," on p. 3-4.)
Cause 6 An error message is displayed on the touch panel display of the machine.
Remedy After confirming the error message, see Chapter 7, "Troubleshooting," in the
Reference Guide and perform the necessary operations according to the error
message displayed.
Printing Problems and Remedies
6
6-5