Preparation For Protocol Settings; Settings From The Operation Panel - Canon LaserBase MF5770 Network Manual

Preparation for Protocol Settings

Before you specify the machine's protocol settings, it is necessary to specify the machine's IP address
to enable communication between the machine and your computers. You can use any of the following
to specify the settings. Specify the settings using the easiest method.
• The machine's operation panel
• NetSpot Device Installer (Canon utility software included in the User Software CD)
• The ARP/PING commands
IMPORTANT
2
• In the following operations, the machine's MAC address is necessary. To check the MAC address from the
machine's operation panel, print a USER DATA LIST. (See Chapter 6, "Reports and Lists," in the Facsimile
Guide.)
• Before you perform the following operations in this section, check that the machine is ON and connected to the
network.
• If you are using ARP/PING commands, the following steps directly allocate the IP address to the machine. For this
machine, in addition to direct allocation of the IP address to the machine, you can use DHCP, BOOTP, or RARP to
specify the IP address. When the machine is started or reset, it checks whether DHCP, BOOTP, or RARP is being
used, and then allocates an IP address using the first available setting method. Because the machine's IP address
is automatically allocated at this time, it is not necessary for you to perform the following operations in this section.
However if you are reallocating the IP address, or if DHCP, BOOTP, or RARP is not used, perform the following
operations.

Settings from the Operation Panel

IMPORTANT
Settings specified from the operation panel become effective after the machine is restarted, after the procedure.
1
Press [Menu].
2
Press [
3
Press [
4
Press [
● If you want to allocate an IP address to the machine automatically:
❑
Select <IP ADDRESS AUTO.> ➞ press [OK].
❑
Press [
❑
Press [
❑
Press [
● If you want to allocate a fixed IP address to the machine:
❑
Select <IP ADDRESS> ➞ press [OK].
❑
Enter the IP address number using the numeric keys ➞ press [OK].
5
Press [
6
Enter the number using the numeric keys ➞ press [OK].
7
Press [
8
Enter the number using the numeric keys ➞ press [OK].
9
Press [
2-2
(+)] to select <NETWORK SETTINGS> ➞ press [OK].
(-)] or [
(+)] to select <LAN SETTINGS> ➞ press [OK].
(-)] or [
(-)] or [ (+)] to select <IP ADDRESS AUTO.> or <IP ADDRESS>.
(+)] to select <ON> ➞ press [OK].
(-)] or [
(+)] to select <DHCP>, <BOOTP>, or <RARP> ➞ press [OK].
(-)] or [
(+)] to select <ON> or <OFF> ➞ press [OK].
(-)] or [
(+)] to select <SUBNET MASK> ➞ press [OK].
(-)] or [
(+)] to select <DEFAULT GATEWAY> ➞ press [OK].
(-)] or [
(+)] to select <ETHERNET DRIVER> ➞ press [OK].
(-)] or [