Canon MF7280 - ImageCLASS B/W Laser Network Manual page 28

2
6
7
8
9
10
2-10
Interface Settings
IMPORTANT
If you reconnect the network cable (for example, reconnect the cable to a different
Ethernet hub) with the power ON, the Auto Detect function will not work even if you
set <Auto Detect> to 'On'. (Connect the cable with the power OFF.)
NOTE
The default setting is 'On'. Use the [Off] setting when you want to specify a
particular Ethernet setting.
Specify <Communication Mode> on the Ethernet Driver
Settings screen.
● If you want to alternately send and receive:
❑
Press [Half Duplex].
● If you want to simultaneously send and receive:
❑
Press [Full Duplex].
Specify <Ethernet Type> on the Ethernet Driver Settings
screen.
● If you want to establish a 10Base-T network connection:
❑
Press [10 Base-T].
● If you want to establish a 100Base-TX network connection:
❑
Press [100 Base-TX].
Confirm the settings you specified ➞ press [OK].
The display returns to the Network Settings screen.
Press [Done] repeatedly until the Additional Functions screen
closes.
Restart the machine.
❑
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.