Table of Contents
Advertisement
Chapter 4: System Commands
Command
system addhttpfilter
system addiproutingtable
system addserver
system addsnmpfilter
system addsyslogfilter
system addsyslogserver
system addtelnetfilter
system addudprelay
system authen
system backup add
system backup delete
system backup disable
system backup enable
system backup pinginterval
system backup pingsamples
system backup retry
system backup stability
Page 4-2
Table 4-1: System Command Listing (Cont.)
Enables blocking all devices except those within
the defined IP address range from using the HTTP
protocol
Defines a new virtual routing table.
Configures a local IP address as the selected serv-
er on the LAN (FTP, SMTP, etc.) for the global con-
figuration.
Validates SNMP clients by defining a range of IP
addresses that are allowed to access the router via
SNMP.
Limits the Syslog server addresses that may be re-
turned by DHCP.
Adds an address to the list of Syslog servers.
Validates Telnet clients by defining a range of IP
addresses that are allowed to access the router via
Telnet.
Create a UDP port range for packet forwarding.
Forces the target router authentication protocol
that is used for security negotiation with the remote
routers when the local side authentication is set.
Adds an IP address to the list of addresses to be
pinged for the Dial Backup option.
Deletes an IP address from the list of addresses to
be pinged for the Dial Backup option.
Disables the Dial Backup option in the router.
Enables the Dial Backup option in the router.
Changes the ping interval for a group, that is, the
number of seconds between pings during a test of
the addresses in the group.
Changes the number of ping samples for a group,
that is, the number of pings performed for each ad-
dress in the group.
Changes the Dial Backup retry period.
Changes the Dial Backup stability period.
Efficient Networks
Command Line Interface Guide
Function
Efficient Networks
®
Router family
®
Advertisement
Table of Contents
