Efficient Networks Router family Command Line Interface Manual page 223

®
Efficient Networks Router family
Command Line Interface Guide
Parameters
***
<remotename>
a
ASCII string
Response
Typical response:
-> rem list internet
INFORMATION FOR <internet>
Status............................... enabled
Our System Name when dialing out.....
Our Password used when dialing out... no
Protocol in use...................... PPP
ATM traffic shaping.................. no
Authentication....................... disabled
Authentication level required........ PAP
Use periodic LCP pings............... yes
Connection Identifier (VPI*VCI)...... 0*38
IP address translation............... off
IP filters defined................... no
Send/Receive Multicast............... off
Block NetBIOS Packets................ off
Compression Negotiation.............. off
IP slave mode (PPP).................. no
Try to reacquire IP addr (PPP)....... yes
Source IP address/subnet mask........ 0.0.0.0/0.0.0.0
Remote IP address/subnet mask........ 0.0.0.0/0.0.0.0
Send IP RIP to this dest............. no
Send IP default route if known..... no
Receive IP RIP from this dest........ no
Receive IP default route by RIP.... no
Keep this IP destination private..... yes
Total IP remote routes............... 1
10.0.0.0/255.255.0.0/1
IPX network number................... 00000000
Use IPX RIP/SAP (negotiate with PPP): yes
Total IPX remote routes.............. 0
Total IPX SAPs....................... 0
Bridging enabled..................... no
®
Efficient Networks
If entered with no parameters, all remote router entries
are listed.
a
Name of the remote router.
Chapter 6: Remote Commands
Page 6-35