Efficient Networks Router family Command Line Interface Manual page 155

®
Efficient Networks Router family
Command Line Interface Guide
Parameters Cont.
<protocol>
<first port>
<last port>
<first private
c
port>
<interface>
a
Integer
b
Integer, 0 - 65,535
c
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must
be specified.
d
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Response
Command prompt.
®
Efficient Networks
Protocol used by the selected server.
<protocolid>
tcp
udp
all
First or only port as seen by the Ethernet interface. Port used by
the selected server.
b
<portid>
ftp
h323
http
smtp
snmp
t120
telnet
tftp
all
Optional, last port in the range of ports as seen by the remote
end for the server on the LAN.
If specified, this is a port remapping of the incoming requests
from the Ethernet interface.
a c,d
Ethernet interface.
,
Chapter 5: Ethernet Interface Commands
a
Numerical protocol ID.
TCP only.
UDP only.
All protocols.
Numerical port value; a value of 0 matches
any port.
File Transfer Protocol (FTP) port.
H.323 port.
Hypettext Transfer Protocol (HTTP) port.
Simple Mail Transfer Protocol (SMTP) port.
Simple Network Management Protocol (SN-
MP) port.
T.120 port.
Telnet port.
Trivial File Transfer Protocol (TFTP) port.
All ports.
Page 5-17