Efficient Networks Router family Command Line Interface Manual page 161

®
Efficient Networks Router family
Command Line Interface Guide
If the packet matches the filter, the specified <action> is performed:
accept
drop
reject
inipsec
outipsec
The following parameters specify the characteristics that an IP packet must have in
order to match the filter. A filter can require any or all of these characteristics.
-p <protocol> | TCP | UDP | ICMP
The packet must have the specified protocol. If no protocol is specified, the filter
matches every protocol.
-sa <first source ip addr>[:<last source ip addr>]
The packet must have a source IP address within the specified address range. If
only one address is specified, the packet must have that source IP address. If no
source IP address is specified, the filter matches any address in the range
0.0.0.0:255.255.255.255.
-sm <source ip mask>
The filter uses the specified mask when comparing the <first source ip addr>...<last
source ip addr> with the source IP address in the IP packet. If no source mask is
specified, the mask used is 255.255.255.255.
-sp <ICMP type> | <first source port>[:<last source port>]
The packet must have a source port that matches the specified ICMP type or that
is within the specified port range. If only one port is specified, the packet must have
that source port. If no source port is specified, the filter matches any source port in
the range 0:0xffff.
-da <first dest ip addr>[:<last dest ip addr>]
The packet must have a destination IP address within the specified address range.
If only one address is specified, the packet must have that destination IP address.
If no destination IP address is specified, the filter matches any address in the range
0.0.0.0:255.255.255.255.
-dm <dest ip mask>
The filter uses the specified mask when comparing the <first dest ip addr>...<last
dest ip addr> with the destination IP address in the IP packet. If no destination
mask is specified, the mask used is 255.255.255.255.
®
Efficient Networks
The packet is allowed to proceed for further processing.
The packet is discarded, without sending an ICMP (Internet Control
Management Protocol) error message.
The packet is discarded and an ICMP error message is returned to
the sender.
The packet is passed to IPSec for decrypting. The filter is intended
to match packets coming from the other IPSec gateway. Although fil-
ters are the mechanism by which packets are passed to IPSec, it is
recommended that you use IKE to manage your IP Security (
Sec (Internet Protocol Security)" on page 5-50.
The packet is passed to IPSec so it can be encrypted and sent to the
other IPSec gateway. The filter is intended to match packets coming
from the local protected network. Although filters are the mechanism
by which packets are passed to IPSec, it is recommended that you
use IKE to manage your IP Security (
)
curity)" on page 5-50.
Chapter 5: Ethernet Interface Commands
)
see "IPSec (Internet Protocol Se-
see "IP-
Page 5-23