Efficient Networks Router family Command Line Interface Manual page 362

Chapter 12: IKE/IPsec Commands
Table 12-1: Internet Key Exchange Command Listing (Cont.)
Command
ipsec enable
ipsec flush
ipsec list
ipsec set authentication
ipsec set authkey
ipsec set direction
ipsec set compression
ipsec set enckey
ipsec set encryption
ipsec set gateway
ipsec set ident
ipsec set mode
ipsec set service
Page 12-4
Function
Enables a defined IPSec security association en-
try.
Clears all IPSec definitions.
Lists one or all of the IPSec security association
(SA) entries.
Selects authentication for the IPSec SA using ei-
ther SHA-1 (Secure Hashing Algorithm 1) or MD5
(Message Digest 5).
Specifies the authentication key for the IPSec se-
curity authentication (SA).
Defines the direction of the IPSec security authen-
tication (SA).
Selects either LZ compression or no compression
for the IPSec security authentication (SA).
Specifies the encryption key for the IPSec security
authentication (SA).
Selects the method of encryption used for the IP-
Sec security authentication (SA): no encryption,
DES (56-bit) encryption, or 3DES (168-bit) encryp-
tion.
Defines the IP address of the IP gateway of the IP-
Sec security authentication (SA).
Specifies the identifier (SPID) for the IPSec tunnel.
Selects the encapsulation mode (tunnel or trans-
port) for the SA.
Selects the authentication and/or encryption ser-
vices used for the IPSec SA.
®
Efficient Networks Router family
Command Line Interface Guide
Efficient Networks
®