Efficient Networks Router family Command Line Interface Manual page 141

®
Efficient Networks Router family
Command Line Interface Guide
Command
eth ipx addr
eth ipx disable
eth ipx enable
eth ipx frame
eth list
eth mtu
eth restart
eth start
eth stop
eth vrrp add
eth vrrp clear password
eth vrrp delete
eth vrrp list
eth vrrp set multicast
eth vrrp set option
eth vrrp set password
eth vrrp set priority
eth vrrp set timeinterval
eth ip remsrcrouteopt
®
Efficient Networks
Table 5-1: Ethernet Interface Command Listing (Cont.)
Sets the IPX network number for the Ethernet LAN
connection.
Disables IPX routing across the Ethernet LAN.
Enables IPX routing across the Ethernet LAN.
Sets the frame encapsulation method.
Lists information about the Ethernet interfaces in-
cluding the status of bridging and routing, IP proto-
col controls, and IP address and subnet mask.
Sets the maximum transfer unit for the Ethernet in-
terface.
Starts a stopped logical Ethernet interface.
Starts a stopped logical Ethernet interface.
Stops a logical Ethernet interface.
Defines a VRRP attribute record for the VRID (vir-
tual router ID).
Clears the password in a VRRP attribute record for
the VRID.
Deletes a VRRP attribute record for the VRID.
Lists the VRRP attribute records for the port and
shows the status of the VRRP router.
Changes the multicast address used for VRRP
router announcements.
Specifies the preemption option in a VRRP at-
tribute record for the VRID.
Specifies the password in a VRRP attribute record
for the VRID.
Specifies the priority attribute in a VRRP attribute
record for the VRID.
Specifies the time interval attribute in a VRRP at-
tribute record for the VRID.
Adds or removes the source routing option.
Chapter 5: Ethernet Interface Commands
Function
Page 5-3