Efficient Networks Router family Command Line Interface Manual page 449

®
Efficient Networks Router family
Command Line Interface Guide
key add
Validates a the key that has been generated for the specific device. Once validated,
adds key to key database. When adding a key enabled feature, the feature is enabled
by default. To disable a feature, use the
entered if one of the following conditions exist:
• The key was generated for a different router.
• A non-revoked and non-expired key has already been added for the
specified feature.
• The same key currently exists in a revoked condition.
• The key state is Manufacturing or Legacy
NOTE:
The key will not be written to flash memory until a
Mgmt Class
Security (R/W)
Input Format
key add <key_string>
Parameters
<key_string>
1H+zWqHlXa32Kir45Nqxean3a4kkvhSIH0H/cAHujbtRanrVpx9yxQZlLT6pCUnbuAZzHsLKin7=
a
The key string is case-sensitive and must be entered exactly as received and with no spaces.
Response
Example response when adding a key for L2TP.
-> key add
10/03/2001-13:03:54:KEF: Load key for feature "l2tp" into DB SUCCEDEED
Example response when adding a key that already exists or has been revoked.
-> key add
10/03/2001-13:50:31:KEF: Load key for feature "l2tp" into DB FAILED
®
Efficient Networks
a
Key string. Example shown below.
1H+zWqHlXa32Kir45Nqxean3a4kkvhSIH0H/cAHujbtRa=
1H+zWqHlXa32Kir45Nqxean3a4kkvhSIH0H/cAHujbtRa=
Chapter 16: Key Commands
key disable command. A key cannot be
save command has been issued.
Page 16-3