Efficient Networks Router family Command Line Interface Manual page 507

®
SpeedStream Router family
Command Line Interface Guide
qos set
Defines one or more parameters of a QoS policy. To view the current configuration of
a policy, use the
NOTE:
The QoS policy must exist (created with the
be disabled prior to configuration.
Mgmt Class
Network (R/W)
Input Format
qos set [<parameter>] <policy name>
Parameters
Multiple parameters can be entered in the same command for a single QoS policy; the
sequence of parameters in not essential. The parameters are listed below.
-sa <source address>
Specifies the source address or range of addresses. Off will disable source-address checking.
-da <destination address>
Specifies the destination address or range of addresses. Off will disable destination-address
checking.
-p <protocol> off | <protocol number>
Specifies the protocol by protocol number or explicitly TCP or UDP. Entering
able the protocol check.
-sp <source port>
Specifies the source port or range of ports by number or specific application. Off dis-
ables the port check.
-dp <destination port> off | <start port number>[:<end port number>]
off | ftp | telnet | smtp | http | snmp |tftp | dns | login | rsh |
h323 | t120
Specifies the destination port or range of ports by number or specific application.
disables the port check.
-pr <priority> high | medium | normal | low
Specifies the priority, with normal the default value.
-ic <incoming code point> off | <code point>
®
Efficient Networks
qos list <policy name> command.
a
off | <start address>[:end address>]
a
off | <start address>[:<end address>]
c
off | <start port number>[:<end port number>]
Chapter 20: QoS Commands
qos append or qos insert
b
tcp | udp
commands) and
off will dis-
Off
Page 20-11