Efficient Networks Router family Command Line Interface Manual page 184

Chapter 5: Ethernet Interface Commands
NOTE:
The password must be the same for every router in the Virtual Router, that is, for
every router in the LAN with the same VRID. For example, if a VRRP interface in
routers A, B, and C has the VRID 7, routers A, B, and C must all specify the same
password for VRID 7.
NOTE:
This command takes effect immediately, but you must save the change if it is to
persist after you restart the interface or reboot the router.
Mgmt Class
Network (R/W)
Input Format
eth vrrp set password <password> <vrid> [<port#>]
Parameters
preempt
<password>
c
<vrid>
d
<port#>
a
ASCII string, 1 - 8 characters.
b
The password is case sensitive.
c
Integer, 1 - 255
d
The default is 0; the parameter may be omitted if the router has only one port.
Example
This command example specifies the password "AbCdEfGh" for VRID 7 using default
port 0.
-> eth vrrp set password AbCdEfGh 7
Response
Command prompt.
Page 5-46
Preempt immediately.
a,b
Password.
Virtual router ID of the VRRP attribute record (integer, 1-255). The
attribute record was created by the command
Physical Ethernet interface (port) number (0 or 1).
®
Efficient Networks Router family
Command Line Interface Guide
eth vrrp add
Efficient Networks
®