Efficient Networks Router family Command Line Interface Manual page 240

Chapter 6: Remote Commands
NOTE:
To use the management address as the source address for a ping, you must specify it
using the -I option on the
192.168.1.2 when pinging destination address 192.168.100.100, specify:
ping -I 192.168.1.2 192.168.100.100
NOTE:
To use the management address as the source address for a copy, you must specify
both the source and destination addresses on the
To list the current management address for the remote router, if any, use the
list. To set a management address for an Ethernet interface, see
Mgmt Class
Network (R/W)
Input Format
remote setmgmtipaddr <ipaddr> <mask> <remotename>
Parameters
a
<ipaddr>
a
<mask>
<remotename>
a
Dotted-decimal notation
b
ASCII string
Response
Command prompt.
Page 6-52
ping command. For example, to use management address
IP address.
IP sub-network mask.
b
Name of the remote router.
®
Efficient Networks
Command Line Interface Guide
copy command.
eth ip mgmt.
Efficient Networks
Router family
remote
®