A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See Value-based command
methods on page 71 for setting absolute and adjustment commands.
Command
set displaymode [target]
set brightness [value]
set contrast [value]
set whitepeaking [value]
set degamma [value]
set red [value]
set green [value]
set blue [value]
set cyan [value]
set magenta [value]
set yellow [value]
set videofreeze [target]
set cc [target]
N
N O T E
Typically, cc1 displays English (U.S.) subtitles, while cc2 displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
Additional VGA source controls
Your VGA source supports all the general source controls described in General source controls on
previous page, as well as the commands listed in this section. These settings are unavailable when
the projector is in Standby mode or when the VGA sources are disconnected.
N
N O T E
Some of these commands are invalid with HDMI input and Composite video sources, and will
return the response "invalidcmd=[command]".
74
Command target range
=SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
=0 to =100
=0 to =100
=0 to =10
=0 to =3
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=on
=off
=cc1
=cc2
=off
Response
displaymode=[target]
brightness=[value]
contrast=[value]
whitepeaking=[value]
degamma=[value]
red=[value]
green=[value]
blue=[value]
cyan=[value]
magenta=[value]
yellow=[value]
videofreeze=[target]
cc=[target]