A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
The following table describes the source selection commands:
Command
get input
set input=[field]
The following table describes the source selection response fields:
Field
VGA1
VGA2
Composite
S-Video
HDMI
None
General source controls
The following source controls apply to all input sources. HDMI connector source controls are
described in this section. These controls are unavailable when the projector is in Standby mode. You
can specify custom color values for all inputs.
These commands inform you of the current source settings.
Command
get displaymode
get brightness
get contrast
get whitepeaking
get degamma
get red
get green
get blue
get cyan
get magenta
get yellow
get videofreeze
get cc
73
Description
Returns the projector's current input.
Sets the input to one of the selectable fields.
Description
Switches source to the VGA 1 input connector.
Switches source to the VGA 2 input connector.
Switches source to the Composite video connector.
If you installed your interactive whiteboard system according to the
instructions, this is the relay from the ECP.
Switches source to the S-Video input connector.
Switches source to the HDMI input port.
A non-selectable value that appears when you enter a "get input"
command while the projector is in Standby mode.
Response
displaymode=[current display mode setting]
brightness=[current brightness setting]
contrast=[current contrast setting]
whitepeaking=[current whitepeaking setting]
degamma=[current degamma setting]
red=[current red color setting]
green=[current green color setting]
blue=[current blue color setting]
cyan=[current cyan color setting]
magenta=[current magenta color setting]
yellow=[current yellow color setting]
videofreeze=[current video freeze setting]
cc=[current closed captioning language setting]