A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
These commands inform you of the current system settings. These commands are available even
when the projector is in Standby mode.
Command
get lamphrs
get syshrs
get fwverddp
get fwvernet
get fwvermpu
get fwverecp
get vgaoutnetenable
get signaldetected
get usb1source
get usb2source
These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See Value-based command methods on page 71 for setting absolute
and adjustment commands.
Command
set autosignal [target]
set lampreminder [target]
set highbrightness [target]
set autopoweroff [value]
set zoom [value]
set projectorid [value]
set hposition [value]
set vposition [value]
set aspectratio [target]
set projectionmode [target]
78
Response
lamphrs=[current lamp hours of operation]
syshrs=[current projector hours of operation]
fwverddp=[current projector firmware version]
fwvernet=[current network firmware version]
fwvermpu=[current processor firmware version]
fwverecp=[current ECP firmware version]
vgaoutnetenable=[current]
signaldetected=[true or false]
usb1source=[Video source associated with the USB 1 connector on
the ECP]
usb2source=[Video source associated with the USB 2 connector on
the ECP]
Command target range
=on
=off
=on
=off
=on
=off
=0 to =240
=0 to =30
=0 to =99
=0 to =100
=-5 to =5
=fill
=match
=16:9
=front
=ceiling
=rear
=rear ceiling
Response
autosignal=[target]
lampreminder=[target]
highbrightness=[target]
autopoweroff=[value]
zoom=[value]
projectorid=[value]
hposition=[value]
vposition=[value]
aspectratio=[target]
projectionmode=[target]