Smart Technologies SMART Board 600i5 Configuration And User's Manual page 30

C H A P T E R 3
Using your interactive whiteboard system
Setting Use
Set to Default? Resets projector settings to their
default values.
USB1 Source Enables touch for the selected video
source (VGA-1, VGA-2, HDMI or
Disabled) by associating the video
source with the room computer USB
receptacle (USB1) on the ECP.
USB2 Source Enables touch for the selected video
source (VGA-1, VGA-2, HDMI or
Disabled) by associating the video
source with the laptop USB receptacle
(USB2) on the ECP.
Native DLP Selects 16:10 or 16:9.
Resolution
18
Notes
If you select Yes, all projector settings
reset to their defaults, reversing any
menu changes you made. This action
is irreversible.
Don't adjust this setting unless you
want to reset all of the applied settings,
or unless you're advised to by a
SMART Support specialist.
The default is VGA-1.
When the user switches to the video
source you select in this setting, the
interactive whiteboard recognizes
touch from the device connected to the
room computer USB receptacle on the
ECP.
Selecting Disabled disables the room
computer USB receptacle on the ECP.
The default is VGA-2.
When the user switches to the video
source you select in this setting, the
interactive whiteboard recognizes
touch from the device connected to the
laptop USB receptacle on the ECP.
Selecting Disabled disables the laptop
USB receptacle on the ECP.
The default is 16:10.
This option is only available on
SMART UF75w projectors with DDP
fimrware version 0.0.2.1 or later.
When you select 16:10, the projector's
native resolution is 1280 × 800.
When you select 16:9, the projector's
native resolution is 1280 × 720.