Resolving Audio Issues - Smart Technologies SMART Board 600i5 Configuration And User's Manual

C H A P T E R 6
Troubleshooting your interactive whiteboard system
has obstructions, or if you swivel the projector too far from the vertical center of your interactive
whiteboard.
Use the instructions in the included SMART Board 660i5,680i5, 685i5 or 690i5 interactive whiteboard
system installation guide (smarttech.com/kb/154547) to eliminate most image alignment issues.
The projector image can slip if the projector is moved often or installed in a location prone to vibration,
such as next to a heavy door. Follow these precautions to help prevent the image from becoming
misaligned:
Make sure that the installation wall is plumb and square and doesn't move or vibrate
l
excessively.
Make sure that there are no obstructions behind the projector's wall-mounting bracket, and that
l
the bracket is firmly secured to the wall according to the installation instructions.
Adjust the projected image. See the included SMART Board 660i5,680i5, 685i5 and 690i5
l
interactive whiteboard system installation guide (smarttech.com/kb/154547) and Adjusting the
image on page 23.

Resolving audio issues

The projector doesn't have integrated speakers, but you can connect an audio system to the audio
output connector in the projector's connection panel. If no sound is coming from your audio system,
perform the following procedure.
g
To resolve audio issues
1. Ensure that the speakers' or audio system's cables are properly connected to the audio output
plug on the projector's connection panel.
2. Press the Mute button on the projector's remote control, and if Audio Mute is on, turn it off.
3. Check the ECP's volume knob or use the projector's remote control to ensure that the volume
isn't at the lowest setting.
4. Ensure that your speaker or audio system is on and that the volume is turned up.
5. Check that your source input, such as your computer or video device, isn't malfunctioning.
Ensure that its audio output is on and that the volume isn't set to the lowest position.
N
N O T E
You must display the source input's video to play its audio through the connected speakers
or audio system.
6. If the previous steps don't resolve the issue, contact your authorized SMART reseller.
53