A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
These commands inform you of the current VGA source settings.
Command
get frequency
get tracking
get saturation
get tint
get sharpness
These commands control the appearance of your VGA source. These settings are unavailable when
the projector is in Standby mode or when the VGA source is disconnected. See Value-based
command methods on page 71 for setting absolute and adjustment commands.
Command
set frequency [value]
set tracking [value]
set saturation [value]
set tint [value]
set sharpness [value]
Additional Composite video source controls
Your Composite video source supports all the general source controls described on the previous page
as well as the commands listed in this section. These settings are unavailable when the projector is in
Standby mode or when the Composite video source is disconnected.
N
N O T E
Some of these commands are invalid with HDMI input and VGA video sources, and will return the
response "invalidcmd=[command]".
These commands inform you of the current Composite video source settings.
Command
get saturation
get tint
get sharpness
These commands control the appearance of your Composite video source. See Value-based
command methods on page 71 for setting absolute and adjustment commands.
Command
set saturation [value]
set tint [value]
set sharpness [value]
75
Response
frequency=[current frequency offset setting]
tracking=[current tracking offset setting]
saturation=[current saturation setting]
tint=[current tint setting]
sharpness=[current sharpness setting]
Command target range
=-5 to =5
=0 to =31
=0 to =100
=0 to =100
=0 to =31
Response
saturation=[current saturation setting]
tint=[current tint setting]
sharpness=[current sharpness setting]
Command target range
=0 to =100
=0 to =100
=0 to =31
Response
frequency=[value]
tracking=[value]
saturation=[value]
tint=[value]
sharpness=[value]
Response
saturation=[value]
tint=[value]
sharpness=[value]