Routing The Cables; Installing Smart Software - Smart Technologies SMART Board 600i5 Configuration And User's Manual

C H A P T E R 2
Installing your interactive whiteboard system

Routing the cables

When connecting cables from your SMART UF75 projector to your interactive whiteboard system,
make sure that all cables pass along the top of the interactive whiteboard wall-mounting bracket and
then down the side of the interactive whiteboard.
When connecting cables from a SMART UF75w projector to the interactive whiteboard, make sure
that all cables pass between the two interactive whiteboard wall-mounting brackets. Space your wall-
mounting brackets 4" (10.2 cm) apart to provide full support for the weight of your interactive
whiteboard.
Cable routing for SMART Board 660 and 680
interactive whiteboards
I
I M P O R T A N T
Do not connect the power cable to a power outlet until you have connected all the cables to the
projector and ECP.

Installing SMART software

You must install SMART software on the computer connected to your interactive whiteboard system
to access all of its features.
Download SMART software from smarttech.com/software. These pages list the minimum hardware
requirements for each software version. If SMART software is already installed on your computer,
take this opportunity to upgrade your software to ensure compatibility.
9
Cable routing for SMART Board 685 and 690
interactive whiteboards