Table of Contents
Advertisement
Audio Recording
You can record audio from the four channels
(CH-1/CH-2/CH-3/CH-4) in synchronization with
the video images on this camera recorder.
Select from the three options below to record the
audio.
Microphone connected to [AUX] terminal
0
Microphone connected to [INPUT1] terminal
0
Microphone connected to [INPUT2] terminal
0
.
Setting the Number of Recording
Channels
Set accordingly for slot A and slot B.
0
Set the number of recording channels in [Main
0
Menu] B [System] B [Record Set] B [Record
Format] B [WAudio]/[YAudio].
(A P133 [ W Audio ] )
(A P134 [ Y Audio ] )
Selecting Audio to Be Recorded in Each
Channel
Select the audio to be recorded in CH-1/CH-2/
CH-3/CH-4.
-
Switch Setting
CH-1
AUX
CH-3
INPUT1
CH-2
AUX
CH-4
INPUT1
INPUT2
Memo :
Set the reference input level of "AUX" using
0
[Main Menu] B [A/V Set] B [Audio Set] B [AUX
Gain].
(A P127 [ AUX Gain ] )
Audio Input
Audio input from [AUX]
terminal
Audio input from [INPUT1]
terminal
Audio input from [AUX]
terminal
Audio input from [INPUT1]
terminal
Audio input from [INPUT2]
terminal
Setting for [INPUT1]/[INPUT2] Input Channel
Set [AUDIO INPUT] signal selection switch 1 or 2
according to the devices to be connected to the
[INPUT1] and [INPUT2] terminals.
Setting
[LINE]
Use this setting when connecting to
an audio device or other equipment.
The reference input level is +4 dBu.
[MIC]
Use this setting when connecting to
a dynamic microphone.
[MIC+48V]
Use this setting when connecting to
a microphone (phantom
microphone) that requires a +48 V
power supply.
Memo :
When "MIC" or "MIC+48V" is selected, set the
0
reference input level in [Main Menu] B [A/V Set]
B [Audio Set] B [Input1 Mic Ref.]/[Input2 Mic
Ref.].
(A P127 [ Input1 Mic Ref. ] )
(A P127 [ Input2 Mic Ref. ] )
Caution :
When connecting a device that does not require
0
a +48 V power supply, make sure that it is not
set to the "MIC+48V" position.
When the [AUDIO INPUT] signal selection
0
switch 1 or 2 is set to "MIC", check to ensure that
a microphone is connected to the [INPUT1]/
[INPUT2] terminal. If you increase the recording
level when a microphone is not connected,
noise from the input terminal may be recorded.
When a microphone is not connected to the
0
[INPUT1]/[INPUT2] terminal, set the [AUDIO
INPUT] signal selection switch 1 or 2 to "LINE".
Description
Audio Recording
69
Advertisement
Table of Contents
