Applying A Service Policy Globally To All Vlan Interfaces In The Same Context - Cisco 4700M Administration Manual

Configuring SNMP
Examples
The following example shows how to use the insert-before command to define the sequential order of
two class maps in the policy map:
host1/Admin(config-pmap-mgmt)# class L4_SSH_CLASS insert-before L4_REMOTE_ACCESS_CLASS

Applying a Service Policy Globally to All VLAN Interfaces in the Same Context

This section describes how to apply an existing policy map globally to all VLAN interfaces in the same
context.
Note the following guidelines when applying a service policy:
•
•
To apply the policy map to a specific VLAN interface only, see the
Note
Specific VLAN Interface"
Restrictions
The ACE allows only one policy of a specific feature type to be activated on a given interface.
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin#(config)#
Step 2
service-policy input policy_name
Example:
host1/Admin(config)# service-policy input
SNMP_MGMT_ALLOW_POLICY
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-52
Policy maps, applied globally in a context, are internally applied on all interfaces existing in the
context.
A policy activated on an interface overwrites any specified global policies for overlapping
classification and actions.
section.
Purpose
Enters global configuration mode.
Globally applies the SNMP management policy map to all of the
VLANs associated with a context.
The keywords and arguments are as follows:
input—Specifies that the traffic policy is to be attached to
•
the input direction of an interface. The traffic policy
evaluates all traffic received by that interface.
policy_name—Name of a previously defined policy map,
•
configured with a previously created policy-map command.
The name can be a maximum of 40 alphanumeric characters.
If you are applying the policy map globally to all of the VLANs
associated with a context
Chapter 7 Configuring SNMP
"Applying a Service Policy to a
OL-20823-01