Cisco 4700M Administration Manual page 152

Configuring Redundant ACEs
host1/Admin(config-if)# alias 192.168.1.1 255.255.255.0
Configure the local redundancy peer appliance, associate the FT VLAN with the peer, configure the
Step 6
heartbeat interval and count, and configure a query interface VLAN.
host1/Admin(config)# ft peer 1
host1/Admin(config-ft-peer)# ft-interface vlan 200
host1/Admin(config-ft-peer)# heartbeat count 20
host1/Admin(config-ft-peer)# heartbeat interval 300
host1/Admin(config-ft-peer)# query-interface vlan 400
host1/Admin(config-ft-intf)# exit
Create at least one FT group on each ACE.
Step 7
host1/Admin(config)# ft group 1
host1/Admin(config-ft-group)#
Associate a context with each FT group. You must associate the local context and the corresponding peer
Step 8
context with the same FT group.
host1/Admin(config-ft-group)# associate-context C1
Associate the peer context with the FT group.
Step 9
host1/Admin(config-ft-group)# peer 1
(Optional) Configure the priority of the FT group on the local appliance.
Step 10
host1/Admin(config-ft-group)# priority 100
(Optional) Configure the priority of the FT group on the peer appliance.
Step 11
host1/Admin(config-ft-group)# peer priority 200
Place the FT group in service.
Step 12
host1/Admin(config-ft-group)# inservice
host1/Admin(config-ft-group)# exit
(Optional) Configure one or more critical objects (gateways or hosts, or interfaces) to track for
Step 13
switchover. For example, to configure a critical interface for tracking, enter:
host1/Admin(config)# ft track interface VLAN100
host1/Admin(config-ft-track-intf)# track-interface vlan 100
host1/Admin(config-ft-track-intf)# peer track-interface vlan 100
host1/Admin(config-ft-track-intf)# priority 50
host1/Admin(config-ft-track-intf)# peer priority 150
host1/Admin(config-ft-track-intf)# ctrl-z
(Optional) Enable autosynchronization of the running- and/or startup-configuration file from the active
Step 14
to the standby context.
host1/Admin(config)# ft auto-sync running-config
host1/Admin(config)# ft auto-sync startup-config
(Optional) Save your configuration changes to Flash memory.
Step 15
host1/Admin(config)# exit
host1/Admin# copy running-config startup-config
(Recommended) Verify your redundancy configuration by using the following commands in Exec mode:
Step 16
host1/Admin# show running-config ft
host1/Admin# show running-config interface
Cisco 4700 Series Application Control Engine Appliance Administration Guide
6-8
Chapter 6 Configuring Redundant ACEs
OL-20823-01