Applying A Service Policy To A Specific Vlan Interface - Cisco 4700M Administration Manual

Chapter 7 Configuring SNMP
Command
no service-policy input policy_name
Example:
host1/Admin(config)# no service-policy
input SNMP_MGMT_ALLOW_POLICY
Step 3
do copy running-config startup-config
Example:
host1/Admin(config)# do copy
running-config startup-config

Applying a Service Policy to a Specific VLAN Interface

This section describes how to apply an existing policy map to a specific VLAN interface. A policy
activated on an interface overwrites any specified global policies for overlapping classification and
actions.
To apply the policy map globally to all VLAN interfaces in the same context, see
Note
Policy Globally to All VLAN Interfaces in the Same Context"
Restrictions
The ACE allows only one policy of a specific feature type to be activated on a given interface.
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin#(config)#
Step 2
interface vlan number
Example:
host1/Admin(config)# interface vlan 50
host1/Admin(config-if)#
Step 3
ip address address
Example:
host1/Admin(config-if)# ip address
172.20.1.100 255.255.0.0
OL-20823-01
Purpose
(Optional) Removes the SNMP management policy map from all
of the VLANs associated with a context.
When you remove a policy, the ACE automatically resets the
associated service policy statistics to provide a new starting point
for the service policy statistics the next time that you attach a
traffic policy to a specific VLAN interface or globally to all
VLAN interfaces in the same context.
(Optional) Copies the running configuration to the startup
configuration.
Purpose
Enters global configuration mode.
Specifies an interface VLAN.
The number argument is the number for a VLAN assigned to the
ACE
This commands enters the interface configuration mode
commands for the VLAN.
Specifies the VLAN IP address.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring SNMP
the"Applying a Service
section.
7-53