Cisco 4700M Administration Manual page 22

Setting Up the ACE
•
•
•
The ACE provides a default answer in brackets [ ] for each question in the setup script. To accept a
default configuration prompt, press Enter, and the ACE accepts the setting. To skip the remaining
configuration prompts, press Ctrl-C any time during the configuration sequence.
The script configuration process described in this section is identical to the script configuration process
Note
performed using the setup CLI command.
Detailed Steps
Follow these steps to configure the ACE using the setup script:
Ensure that you have established a direct serial connection between your terminal or a PC and the ACE
Step 1
(see the
Press the power button on the front of the ACE and the boot process occurs. See the Cisco Application
Step 2
Control Engine Appliance Hardware Installation Guide for details.
At the login prompt, log into the ACE by entering the login username and password. By default, the
Step 3
username and password are admin. For example, enter:
Starting sysmgr processes.. Please wait...Done!!!
switch login: admin
Password: admin
At the prompt "Enter the password for "admin:", change the default Admin password. If you do not
Step 4
change the default Admin password, after you upgrade the ACE software you will only be able to log in
to the ACE through the console port.
Enter the new password for "admin": xxxxx
Confirm the new password for "admin": xxxxx
admin user password successfully changed.
At the prompt "Enter the password for "www:", change the default www user password. If you do not
Step 5
change the default www user password, the www user will be disabled and you will not be able to use
Extensible Markup Language (XML) to remotely configure an ACE until you change the default www
user password.
Enter the new password for "www": xxxxx
Confirm the new password for "www": xxxxx
www user password successfully changed.
At the prompt "Would you like to enter the basic configuration dialog? (yes/no):", type yes to continue
Step 6
the setup (or select no to or bypass its operation and directly access the CLI).
At the prompt "Enter the Ethernet port number to be used as the management port (1-4):? [1]:", specify
Step 7
the Ethernet port that you want to use to access the Device Manager GUI. Valid entries are 1 through 4.
The default is Ethernet port 1. Press Enter.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-6
Extended IP access list that allows IP traffic originating from any other host addresses.
Traffic classification (class map and policy map) created for management protocols HTTP, HTTPS,
ICMP, SSH, Telnet, and XML-HTTPS. HTTPS is dedicated for connectivity with the Device
Manager GUI.
VLAN interface configured on the ACE and a policy map assigned to the VLAN interface.
"Establishing a Console Connection on the ACE"
Chapter 1
section).
Setting Up the ACE
OL-20823-01