Cisco 4700M Administration Manual page 133

Chapter 5 Displaying ACE Hardware and Software System Information
Table 5-3
Table 5-3 Field Descriptions for the show processes Command
Field
PID
State
PC
Start_cnt
TTY
Process
Table 5-4
Table 5-4 Field Descriptions for the show processes cpu Command
Field
CPU Utilization
PID
Runtime (ms)
Invoked
uSecs
1 Sec
5 Sec
1 Min
5 Min
Process
OL-20823-01
describes the fields in the show processes command output for the summary CPU information.
Description
Process identifier.
Process state. Included below is a summary of the different process state codes that can appear to
describe the state of a process:
D—Uninterruptible sleep (usually I/O related)
•
ER—Error while running
•
NR—Not running
•
R—Running or runnable (on run queue)
•
S—Interruptible sleep (waiting for an event to complete)
•
T—Stopped, either by a job control signal or because it is being traced
•
W—Paging
•
X—Process is dead
•
Z—Defunct ("zombie") process, terminated but not reaped by its parent
•
Current program counter in hexadecimal format.
Number of times a process has been started.
Terminal that controls the process. A "—" usually means a daemon is not running on any particular
tty.
Name of the process.
describes the fields in the show processes cpu command output.
Description
Lists the percentage of CPU utilization for the ACE for a 5-second interval, 1-minute interval,
and a 5-minute interval
Process identifier
CPU time the process has used, expressed in milliseconds
Number of times that the process has been invoked
Microseconds of CPU time as an average for each process invocation
CPU utilization as a percentage for the last second
CPU utilization as a percentage for the last 5 seconds
CPU utilization as a percentage for the last minute
CPU utilization as a percentage for the last 5 minutes
Name of the process
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Displaying System Processes and Memory Resources Limits
5-5