Configuring Snmp; Task Flow For Configuring Snmp - Cisco 4700M Administration Manual

Chapter 7

Configuring SNMP

Configuring SNMP
This section describes how to configure SNMP and includes the following topics:
•
•
•
•
•
•
•
•
•
•
•

Task Flow for Configuring SNMP

Follow these steps to configure SNMP on the ACE:
If you are operating in multiple contexts, observe the CLI prompt to verify that you are operating in the
Step 1
desired context. If necessary, log directly in to, or change to, the correct context.
host1/Admin# changeto C1
host1/C1#
The rest of the examples in this procedure use the Admin context, unless otherwise specified. For details
on creating contexts, see the Cisco 4700 Series Application Control Engine Appliance Virtualization
Configuration Guide.
Enter configuration mode.
Step 2
host1/Admin# config
Enter configuration commands, one per line. End with CNTL/Z
host1/Admin(config)#
Configure one or more SNMP users from the ACE CLI.
Step 3
host1/Admin(config)# snmp-server user joe Network-Monitor auth sha abcd1234
host1/Admin(config)# snmp-server user sam Network-Monitor auth md5 abcdefgh
host1/Admin(config)# snmp-server user Bill Network-Monitor auth sha abcd1234 priv abcdefgh
Create an SNMP community and identify access privileges.
Step 4
host1/Admin(config)# snmp-server community SNMP_Community1 group Network-Monitor
Specify the contact name for the SNMP system.
Step 5
host1/Admin(config)# snmp-server contact "User1 user1@cisco.com"
Specify the SNMP system location.
Step 6
host1/Admin(config)# snmp-server location "Boxborough MA"
OL-20823-01
Task Flow for Configuring SNMP
Configuring SNMP Users
Defining SNMP Communities
Configuring an SNMP Contact
Configuring an SNMP Location
Configuring SNMP Notifications
Unmasking the SNMP Community Name and Community Security Name OIDs
Assigning a Trap-Source Interface for SNMP Traps
Accessing ACE User Context Data Through the Admin Context IP Address
Configuring an SNMPv3 Engine ID for an ACE Context
Configuring SNMP Management Traffic Services
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring SNMP
7-31