Configuring The Date And Time; Setting The System Time And Date - Cisco 4700M Administration Manual

Setting Up the ACE
Command
no banner motd
Example:
host1/Admin(config)# do show banner motd
Step 3
do show banner motd
Example:
host1/Admin(config)# no banner motd
Step 4
do copy running-config startup-config
Example:
host1/Admin(config)# do copy
running-config startup-config
Examples
The following example shows how to span multiple lines and use tokens to configure the banner
message:
host1/Admin(config)# banner motd #
Enter TEXT message. End with the character '#'.
================================
Welcome to Admin Context
--------------------------------
Hostname: $(hostname)
Tty Line: $(line)
=================================
#

Configuring the Date and Time

This section describes how to manually configure the date, time, and time zone settings for an ACE.
You can automatically set the date and time of the ACE by synchronizing to a Network Time Protocol
(NTP) server. For details, see the
This section contains the following topics:
•
•
•

Setting the System Time and Date

This section describes how to set the time and the date for an ACE.
If you wish to use the Network Time Protocol (NTP) to automatically synchronize the ACE system clock
Note
to an authoritative time server (such as a radio clock or an atomic clock), see the
ACE with an NTP Server"
clock.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-16
Setting the System Time and Date
Configuring the Time Zone
Adjusting for Daylight Saving Time
section. In this case, the NTP time server automatically sets the ACE system
Purpose
(Optional) Replace a banner or a line in a multi-line banner.
(Optional) Display the configured banner message.
(Optional) Copies the running configuration to the startup
configuration.
"Synchronizing the ACE with an NTP Server"
Chapter 1 Setting Up the ACE
section.
"Synchronizing the
OL-20823-01