Configuring An Ft Peer - Cisco 4700M Administration Manual

Configuring Redundant ACEs
Command
no alias ip_address netmask
Example:
host1/Admin(config-if)# no alias
192.168.1.1 255.255.255.0
Step 4
do copy running-config startup-config
Example:
host1/Admin(config-if)# do copy
running-config startup-config

Configuring an FT Peer

This section describes how to configure an FT peer definition on both peer ACEs.
Restrictions
This topic includes the following restrictions:
•
•
•
•
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin#(config)#
Step 2
ft peer peer_id
Example:
host1/Admin(config)# ft peer 1
host1/Admin(config-ft-peer)
no ft peer peer_id
Example:
host1/Admin(config)# no ft peer 1
Step 3
ft-interface vlan vlan_id
Example:
host1/Admin(config-ft-peer) ft-interface
vlan 200
Cisco 4700 Series Application Control Engine Appliance Administration Guide
6-12
You must create FT peers in the admin context only.
You can configure a maximum of two ACEs as redundancy peers.
Before you can remove an FT peer from the configuration by using the no form of the command,
you must remove the peer from the FT group (see the
You cannot delete a query interface if it is associated with a peer. You must disassociate the interface
from the peer first, and then you can delete the interface.
Purpose
(Optional) Removes an alias IP address.
(Optional) Copies the running configuration to the startup
configuration.
"Configuring an FT Group"
Purpose
Enters global configuration mode.
Creates an FT peer.
The peer_id argument specifies a unique identifier for the peer.
You can only enter 1.
This command enters the FT peer configuration mode.
(Optional) Removes the FT peer from the configuration.
Associates an FT VLAN with a peer.
The vlan_id argument specifies the identifier of an existing
VLAN. Enter an integer from 2 to 4094.
Chapter 6 Configuring Redundant ACEs
section).
OL-20823-01