Making Duplex Copies (Duplex Copy); Adjusting Copy Density (Density); Changing Document Type (Document Type) - Oki MPS4200mb Basic User Manual

Making Duplex Copies (Duplex
Copy)
You can copy 1-sided (simplex) and 2-sided
(duplex) documents on to one side (simplex) or
both sides (duplex) of a sheet of paper. You can
also select the binding position from either long-
edge or short-edge binding.
Specify the appropriate orientation of the
document in [Direction] beforehand to get the
copy result you want.
Note
Use standard size plain paper for duplex copies. Using
non-standard paper may cause a paper jam in the duplex
unit of your machine.
Duplex printing cannot be done while paper is fed by
Manual Feeder in MB461.
Reference
For details on the available paper for your machine, refer
to "Loading Paper" P. 32.
For details on how to configure the [Direction] setting,
refer to "Changing Image Orientation of Document
(Direction)" P. 75.
Long-Edge Binding
Copies your document to be bound along the
long edge of the paper.
Short-Edge Binding
Copies your document to be bound along the
short edge of the paper.
Reference
To set margins for binding, refer to the User's Manual
Advanced.
Enabling Duplex Copies
Press the to enter the [Change
1
Settings] menu.
Press the to select [Duplex Copy]
2
and then press
OK
.
Press the
3
and then press
Settable Values for Printing Method:
OFF (Simplex)*
Simplex document → Duplex
Simplex document → Duplex
Duplex document → Duplex printing
Duplex
Duplex SE → Simplex printing
Press the
4
displayed.
Note
"
You can copy duplex to duplex
copies only when scanning the documents from the ADF.
Memo
When making duplex copies using the document glass, the
continuous scan mode is automatically enabled. Follow the
on-screen instructions.
Adjusting Copy Density
(Density)
You can adjust the copy density from 7 levels.
Press the
1
Settings] menu.
Press the
2
and then press
Check that [Density] is selected and
3
then press
Press the
4
density and then press
Settable Density Values:
+3 +2
Memo
[0] is the standard value. To darken the document
image, select [+1], [+2] or [+3] (most dense).
Conversely, to lighten the document image, select
[-1], [-2] or [-3] (least dense).
Press the
5
displayed.
Changing Document Type
(Document Type)
You can select the document type to make copies
at the most suitable quality for your needs.
Press the
1
Settings] menu.
- 77 -
Configuring Copy Settings
to select the desired value
.
OK
LE
SE
LE → Simplex printing
*indicates the factory default.
until the start screen is
" "
or duplex to simplex
to enter the [Change
to select [Image Settings]
.
OK
.
OK
or to select the desired
.
OK
+1 0* -1 -2 -3
*indicates the factory default.
until the start screen is
to enter the [Change
2
"