Settings For Each Dialing Type - Oki MPS4200mb Basic User Manual

Connecting PBX, Home Telephone or
Business Phone
Plug the [Telephone cable] connected to the
[Public Line (Analog)] into the [LINE
connection] of your machine.
Remove the telephone connector cover.
Plug the telephone cable connected to a control
device including PBX, etc. into the [TEL
connection] of your machine.
LINE connection
Telephone cable
- Home Telephone -
In general, many telephones are connected with
one or two telephone lines, and the internal
communication and door phone can be done. This
is simple switching equipment for household.
- Business Phone -
In general, it can accommodate more than two
telephone lines, these telephone lines can be
shared with a lot of telephones, and the internal
communication can be done. This is simple
switching equipment.
TEL connection
Control device
including PBX,
etc.
Public Line
(Analog)
Basic Settings for Faxing (for MB471, MB491, ES4191 MFP only)
Connecting as an Internal Telephone
Plug the [Telephone cable] connected to a
control device including PBX, etc. into the [LINE
connection] of your machine.
LINE connection
Memo
Set [PBX Line] to [ON]. Refer to
in detail.

Settings for each dialing type

The factory default [MF (Tone)/DP (Pulse)] is
set to [Tone].
For push-button phones, if you hear a "Beep, boop,
beep" sound, leave [MF (Tone)/DP (Pulse)] as
[Tone].
For push-button type phones, if you do not hear a
"Beep, boop, beep" sound, or if you are using a
rotating-dial type phone, set [MF (Tone)/DP
(Pulse)] to [Pulse].
How to Configure Settings
Press the <SETTING> key on the
1
operator panel.
Press the
2
and press
Enter the administrator password.
3
The factory default password is "aaaaaa".
Select [Enter], and press
4
Press the
5
and press
Press , select [MF (Tone)/DP
6
(Pulse)], and then press
- 43 -
Control device
including PBX,
etc.
Telephone cable
"PBX Connecting" P. 45
to select [Admin Setup],
.
OK
.
OK
to select [User Install],
.
OK
.
OK
1
Public Line
(Analog)