Setup To Use The Wsd Scan; Installation Procedure - Oki MPS4200mb Basic User Manual

Setup to use the WSD Scan

The following explains how to set up the PC to use the WSD Scan function. In order to use the WDS
Scan function, install this device on the PC.
WSD Scan can be used from Scan To Local PC and Scan To Remote PC via Network.
To use WSD Scan, the machine has to be connected with the computer which Windows Vista/
Windows7/ Windows Server 2008/ Windows Server 2008R2 was installed via Network.
Reference
Before starting the following procedure, be sure to check the network connection. For details, see
Connection" P. 47.
Note
If a scanner is used via WSD Scan connection and if the device IP address is changed, select [Uninstall] in step 2 of
Installation procedure and uninstall the scanner, and then execute the install procedure again.

Installation procedure

Memo
When you follow the procedure below, the WIA is installed
automatically as the scanner driver.
Note
Before starting the installation, select [Network and
Sharing Center] from the Control Panel and make sure
that Network Search is enabled.
From the [Start] menu, select
1
[Network]. The devices connected to
the network are displayed.
Right-click the MB491 icon under
2
[Multifunction Devices] and select
[Install].
If the [User Account Control] dialog box is
displayed, click [Yes].
When the balloon message saying that
3
the installation is complete is displayed
on the task bar, click the balloon to check
the details, and click [Close].
Check the device installation on the machine as
follows.
Press the <SCAN> key on the operator
4
panel.
Press the
5
then press
Check that [Select A Connecting PC] is
6
selected, and press
Press the
7
Scan], and press
Make sure that the device installation PC
8
is displayed as the destination PC.
Memo
A maximum of 50 PCs can be registered.
- 101 -
Setup to use the WSD Scan
"Network
to select [Local PC] and
.
OK
.
OK
to select [From WSD
.
OK
4