Oki MPS4200mb Basic User Manual page 151

Symptom
Unable to copy.
Unable to copy mixed
size documents.
Unable to sort copies.
The Copied Output Is Different from the Original Document
Symptom
The copied output is
different from the
original document.
The size of the copied
output is different from
the size of the original
document.
A part of the document
image is missing on the
copied output.
Troubles after Starting to Copy
Symptom
The machine is slow to
start copying.
A copy job is cancelled.
Point to check
Is the Continuous Scan mode on?
Is the machine off line?
Do you have access to make
copies?
Is [Mixed Size] set to [OFF]?
Is the size of your document
compatible for making mixed size
copies?
Is paper of all the sizes of your
original loaded?
Is [Sort] set to [OFF]?
Point to check
Is [DuplexCopy] enabled?
Is [Mixed Size] set to [ON]?
Is the proper size paper for the
document loaded on the paper
tray?
Is the zoom ratio properly set?
Is [Repeat] set to [ON]?
Is [Edge Erase] set to [ON]?
Is [Margin] set to [ON]?
Is [N-in-1] set to [ON]?
Point to check
Is [Warming Up] or [Preparing]
displayed on the display screen?
Is any error occurring?
Is there paper on the MP tray?
Remedy
Select [Scan completed] on the
display screen.
Press the <PRINT> key on the
operator panel, and then select
[On-Line/Off-Line].
Enter your authorized PIN or user
name and password.
Set [Mixed Size] to [ON].
Use documents of sizes supported
for mixed size copying.
Load paper of the required sizes on
each paper tray. The paper trays
need to be set to [ON] or [ON
(Prior)] from the <SETTING>
key > [Paper Setup] > [Select
Tray] > [Copy].
Set [Sort] to [ON].
Remedy
Set [DuplexCopy] to [OFF].
Set [Mixed Size] to [OFF].
Load the proper size paper for the
document.
Set the proper zoom ratio.
Set [Repeat] to [OFF].
Set [Edge Erase] to [OFF].
Set [Margin] to [OFF].
Set [N-in-1] to [OFF].
Remedy
The machine is preparing.
Wait until it starts copying.
A copy job is cancelled when
specific errors occur while copying.
Clear the error and start the copy
job again.
When copying using paper from
the MP tray, check if enough paper
is loaded on the MP tray before
starting to copy. And, press the
<SETTING> key and select
[Paper Setup] > [Select Tray] >
[Copy] > [MP tray], and then
check that [ON] or [ON (Prior)] is
selected.
- 151 -
Other Issues
Reference
P.76
-
P.119
Advanced
Advanced
-
Advanced
Reference
P.77
Advanced
P.32
7
P.75
Advanced
Advanced
Advanced
Advanced
Reference
-
P.132
-