Traceroute Ipv4 - NETGEAR GSM7212P User Manual

Result - Displays the result after the switch send a Ping IPv6 request to the specified IPv6
4.
address.

Traceroute IPv4

Use this screen to tell the switch to send a TraceRoute request to a specified IP address or
Hostname. You can use this to discover the paths packets take to a remote destination. Once
you click the APPLY button, the switch will send traceroute and the results will be displayed
below the configurable data.
If a reply to the traceroute is received, you will see:
1 x.y.z.w 9869 usec 9775 usec 10584 usec
•
2 0.0.0.0 0 usec * 0 usec * 0 usec *
•
3 0.0.0.0 0 usec * 0 usec * 0 usec *
•
Hop Count = w Last TTL = z Test attempt = x Test Success = y.
•
To display the Traceroute IPv4 page, click Maintenance
IPv4.
To configure the Traceroute settings and send probe packets to discover the route to a host
on the network:
Use IP Address/Hostname to enter the IP address or Hostname of the station you want
1.
the switch to discover path. The initial value is blank. The IP Address or Hostname you
enter is not retained across a power cycle.
Optionally, configure the following settings:
2.
Probes Per Hop - Enter the number of probes per hop. The initial value is default. The
•
Probes per Hop you enter is not retained across a power cycle.
MaxTTL - Enter the maximum TTL for the destination. The initial value is default
•
value. The MaxTTL you enter is not retained across a power cycle.
Web Management User Guide
351
 
Troubleshooting Traceroute