Vlan Membership - NETGEAR GSM7212P User Manual

All ports are configured to an Acceptable Frame Types value of Admit All Frames.
•
All ports are configured with Ingress Filtering disabled.
•
All ports are configured to transmit only untagged frames.
•
GVRP is disabled on all ports and all dynamic entries are cleared.
•
Internal VLAN Configuration
This page displays the allocation base and the allocation mode of internal VLAN. The internal
VLAN is reserved by port-based routing interface and invisible to the end user. Once these
internal VLANs are allocated by port-based routing interface, they are cannot be assigned to
a routing VLAN interface.
Use Internal VLAN Allocation Base to specify the VLAN Allocation Base for the routing
1.
interface. The default base of the internal VLAN is 1 to 4093.
Use the optional Internal VLAN Allocation Policy field to specify a policy for the internal
2.
VLAN allocation. There are two policies supported: ascending and descending.

VLAN Membership

To display the VLAN Membership page, click Switching
Membership.
To configure VLAN membership:
Use VLAN ID to select the VLAN ID for which you want to display or configure data.
1.
Use Group Operation to select all the ports and configure them:
2.
Untag All - Select all the ports on which all frames transmitted for this VLAN will be
•
untagged. All the ports will be included in the VLAN.
Tag All - Select the ports on which all frames transmitted for this VLAN will be tagged.
•
All the ports will be included in the VLAN.
Remove All - All the ports that may be dynamically registered in this VLAN via GVRP.
•
This selection has the effect of excluding all ports from the selected VLAN.
Use Port List to add the ports you selected to this VLAN. Each port has three modes:
3.
Web Management User Guide
100
  
VLAN Advanced VLAN