NETGEAR GSM7212P User Manual page 159

selection will determine the port's duplex mode and transmission rate. The factory default is
auto.
Use the Link Trap object to determine whether to send a trap when link status changes.
6.
The factory default is enabled.
Use Maximum Frame Size to specify the maximum Ethernet frame size the interface
7.
supports or is configured, including ethernet header, CRC, and payload (1518 to 9216). The
default maximum frame size is 1518.
Click CANCEL to update the switch with the values you entered. If you want the switch to
8.
retain the new values across a power cycle you must perform a save.
Click APPLY to update the switch with the values you entered. If you want the switch to
9.
retain the new values across a power cycle you must perform a save.
Field
Port Type
Physical Status
Link Status
ifIndex
Web Management User Guide
Description
For normal ports this field will be "normal." Otherwise
the possible values are:
• Mirrored - The port is a mirrored port on which all
the traffic will be copied to the probe port.
• Probe - Use this port to monitor mirrored port.
• Trunk Number - The port is a member of a Link
Aggregation trunk. Look at the LAG screens for
more information.
Indicates the port speed and duplex mode.
Indicates whether the Link is up or down.
The ifIndex of the interface table entry associated
with this port.
159