Udp Relay - NETGEAR GSM7212P User Manual

UDP Relay

From the UDP Relay link, you can access the following pages:
• UDP Relay Global Configuration
• UDP Relay Interface Configuration
UDP Relay Global Configuration
To display the UDP Relay Global Configuration page, click System > Services > UDP Relay>
UDP Relay Global Configuration. A screen similar to the following displays.
Use Admin Mode to enable or disable the UDP Relay on the switch. The default value
1.
is disable.
Use Server Address to specify the UDP Relay Server Address in x.x.x.x format.
2.
Use UDP Port to specify the UDP Destination Port. These ports are supported:
3.
DefaultSet - Relay UDP port 0 packets. This is specified if no UDP port is selected
•
when creating the Relay server.
dhcp -Relay DHCP (UDP port 67) packets.
•
domain - Relay DNS (UDP port 53) packets.
•
isakmp - Relay ISAKMP (UDP port 500) packets.
•
mobile-ip - Relay Mobile IP (UDP port 434) packets
•
nameserver - Relay IEN-116 Name Service (UDP port 42) packets
•
netbios-dgm - Relay NetBIOS Datagram Server (UDP port 138) packets
•
netbios-ns - Relay NetBIOS Name Server (UDP port 137) packets
•
ntp - Relay network time protocol (UDP port 123) packets.
•
pim-auto-rp - Relay PIM auto RP (UDP port 496) packets.
•
rip - Relay RIP (UDP port 520) packets
•
tacacs - Relay TACACS (UDP port 49) packet
•
tftp - Relay TFTP (UDP port 69) packets
•
Web Management User Guide
on page 55
on page 56
55