Traceroute Ipv4 - NETGEAR M7100 Series User Manual

M6100, M5300, and M7100 Series Managed Switches
Select the Ping type from the list.
8.
Possible values are as follows:
Global. Ping a global IPv6 address.
•
Link Local. Ping a link-local IPv6 address over the specified interface. This field is
•
shown when Interface is selected as the ping option.
Use IPv6 Address/Hostname to enter the IPv6 address or host name of the station for the
9.
switch to ping.
The initial value is blank. The format is xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx. The
maximum number of characters is 255.
Use Count to enter the number of echo requests send.
10.
The range is 1 to 15. The default value is 3.
Enter the Interval in seconds between ping packets.
11.
The range is 1 to 60. The default value is 3.
Use Datagram Size to enter the datagram size.
12.
The valid range is 0 to 13000. The default value is 0 bytes.
Enter the Source IP address or interface to use when sending the echo request packets.
13.
If the source is not required, select None as the source option. Possible values are as
follows:
None. The source address of the ping packet would be the address of the default
•
outgoing interface.
IPv6 Address. The source IPv6 address to use when sending the echo request
•
packets. This field is shown when IPv6 Address is selected as the source option.
Interface. The interface to use when sending the echo request packets. This field is
•
shown when Interface is selected as the source option.
Values configured in the fields in this screen are not saved to the
Note:
switch. As a result, refreshing the screen sets these fields to the default
values.
Click the Apply button.
14.
Pings are sent to the specified IPv6 address or host name. The switch sends the number
of pings specified in the Count field, and the results are displayed below the configurable
data in the Results area.

Traceroute IPv4

Use this screen to tell the switch to send a traceroute request to a specified IP address or
host name. You can use this to discover the paths packets take to a remote destination. Once
you click the Apply button, the switch sends traceroute and the results are displayed below
the configurable data.
Maintenance
734