Send An Ipv4 Traceroute - NETGEAR S350 Series User Manual

S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP

Send an IPv4 Traceroute

You can configure the switch to send a traceroute request to a specified IP address or host
name. You can use this to discover the paths that packets take to a remote destination.
When you send a traceroute, the switch displays the results below the configurable data.
If a reply to the traceroute is received, the following message displays:
traceroute to x.y.z.w (x.y.z.w), maxTTL hops max, size byte packets
initTTL x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+1 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+2 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms

To send an IPv4 traceroute:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Maintenance > Troubleshooting > Traceroute IPv4.
Access the Local Browser Interface
Maintenance
Change the Default IP Address of the
on page 19.
321